Home > Online Store > Space Case Globe

Space Case Globe

The Globe Incense Burner Instructions

Take base cap off of glass bubble. The pin in the center of the cap is very sharp. Be careful of the tip!
Detach one side of the hose from base cap and attach the mouthpiece to it.
Now, get your favorite incense in a cone form, about a 1/2 inch cone will do, and place it on the pin with cone pointing up.
Time to light it up. Light the tip of the incense cone. Just the tip, until its red hot and starts to smoke. Caution! Do not let your incense catch fire for more than a few seconds! Just blow flame out and light again until you get just the tip red hot and smokin!
Once you get the incense going, place glass bubble over base cap. The incense is now sealed in.
Let the incense burn for a bit - till smoke starts to fill the bubble. When you see smoke start to leak out of the exhaust hole, its ready.
Now enjoy. Let the essence of pure ALOHA fill the air with your favorite incense in your control.

The Globe Incense Burner Cleaning Instructions

For glass bubble, drop a cotton ball in and add 2 oz. of alcohol. Swirl around for a minute or two. Then pour out excess liquid. Use cotton ball to wipe inside of bubble before throwing it away. Once clean, just rinse with water & dry.
For Base Cap: A paper towel dampened with alcohol works well to clean the plate and pin. For exhaust and intake holes, use Q-tips dipped in alcohol. Clean thoroughly and let dry. Do the same with the mouth piece.
For the Hose, boiling it in water works best. Boil for five minutes. Next rinse inside of hose with alcohol then water and let dry. The easiest way to get a clean hose is to get a new one.

Best Sellers